lacompanies.blogg.se

When I run the command, "dmesg | grep firmware", I get the following error messsages SET failed on device wlan0 Invalid argument.ĭetermining IP information for wlan0.SIOCSIFFLAGS: No such file or directory When I attempt to activate it, I get the following error message:Įrror for wireless request "Set Mode" (8B06) : In the "Network Configuration" gui, I see that wlan0 is inactive. Memory at fe7f8000 (32-bit, non-prefetchable) Ĭapabilities: Power Management version 2

My wireless adapter is a LinkSys WMP54G v4.1 PCI card.įrom the command "lspci -v" i learned the chipset information as follows:Ġ2:00.0 Network controller: RaLink RT2561/RT61 802.11g PCIįlags: bus master, slow devsel, latency 64, IRQ 16 Here are my general questions:ġ) Should hardware drivers be included in a repository? Or, can they be installed separately without much risk? I found a driver that may be the correct one. I am having difficulty getting my wireless card to work (on CentOS v5.3 x86_64).